Specifications

show controllers vsi descriptor
MP-437
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show controllers vsi descriptor
Note Effective with Cisco IOS Release 12.4(20)T, the show controllers vsi descriptor command is not
available in Cisco IOS software.
To display information about a switch interface discovered by the Multiprotocol Label Switching
(
MPLS) Label Switch Controller (LSC) through a Virtual Switch Interface (VSI), or if no descriptor is
specified, about all such discovered interfaces, use the show controllers vsi descriptor command in user
EXEC or privileged EXEC mode.
show controllers vsi descriptor [de
scriptor]
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines Specify an interface by its (switch-supplied) physical descriptor.
Per-interface information includes the following:
• Interface name
• Physical descriptor
• Interface status
• Physical interface state (supplied by the switch)
• Acceptable VPI and VCI ranges
• Maximum cell rate
• Available cell rate (forward/backward)
• Available channels
Similar information is displayed when you enter the show
controllers xtagatm privileged EXEC
command. However, you must specify a Cisco IOS interface name instead of a physical descriptor.
Examples The following is sample output from the sho
w controllers vsi descriptor command:
Router# show controllers vsi descriptor 12.2.0
descriptor (Optional) Physical descriptor. For the Cisco BPX switch, the physical
descriptor has the following form: slot.port.0
Release Modification
12.0(5)T This command was introduced.
12.4(20)T This command was removed.