Specifications

show controllers vsi status
MP-443
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show controllers vsi status
Note Effective with Cisco IOS Release 12.4(20)T, the show controllers vsi status command is not available
in Cisco IOS software.
To display a one-line summary of each Virtual Switch Interface (VSI)-controlled interface, use the sho
w
controllers vsi status command in user EXEC or privileged EXEC mode.
show controllers vsi status
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines If an interface is discovered by the LSC, but no extended Multiprotocol Label Switching (MPLS) ATM
i
nterface is associated with it through the extended-port command, then the interface name is marked
<unknown>, and interface status is marked n/a.
Examples The following is sample output from the sho
w controllers vsi status command:
Router# show controllers vsi status
Interface Name IF Status IFC State Physical Descriptor
switch control port n/a ACTIVE 12.1.0
XTagATM0 up ACTIVE 12.2.0
XTagATM1 up ACTIVE 12.3.0
<unknown> n/a FAILED-EXT 12.4.0
Table 20 describes the significant fields shown in the display.
Release Modification
12.0(5)T This command was introduced.
12.4(20)T This command was removed.
Ta b l e 20 show controllers vsi status Field Descriptions
Field Description
Interface Name The (Cisco IOS) interface name.
IF Status Overall interface status. Can be “up,” “down,” or “administratively down.”