Specifications

show controllers vsi traffic
MP-445
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show controllers vsi traffic
Note Effective with Cisco IOS Release 12.4(20)T, the show controllers vsi traffic command is not available
in Cisco IOS software.
To display traffic information about Virtual Switch Interface (VSI)-controlled interfaces, VSI sessions,
or
virtual circuits (VCs) on VSI-controlled interfaces, use the show controllers vsi traffic command in
user EXEC or privileged EXEC mode.
show controllers vsi traffic {descr
iptor descriptor | session session-number | vc [descriptor
descriptor [vpi vci]]}
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines If none of the keywords is specified, traffic for all interfaces is displayed. You can specify a single
i
nterface by its (switch-supplied) physical descriptor. For the BPX switch, the physical descriptor has
the form
slot.port. 0
If a session number is specified, the output displays VSI protocol traffic by message type. The VC traffic
displa
y is also displayed by the show xmplsatm vc cross-connect traffic descriptor command.
Examples The following is sample output from the sho
w controllers vsi traffic command:
Router# show controllers vsi traffic
Phys desc: 10.1.0
Interface: switch control port
descriptor descriptor Displays traffic statistics for the specified descriptor.
session se
ssion-number Displays traffic statistics for the specified session.
vc Displays traffic statistics for the specified VC.
descriptor [descr
iptor
descriptor]
Specifies the name of the physical descriptor.
vpi Virtual path identifier (0 to 4095).
vci Virtual circuit identifier (0 to 65535).
Release Modification
12.0(5)T This command was introduced.
12.2(4)T The VPI range of values was extended to 4095.
12.4(20)T This command was removed.