Specifications

show controllers xtagatm
MP-449
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show controllers xtagatm
Note Effective with Cisco IOS Release 12.4(20)T, the show controllers xtagatm command is not available
in Cisco IOS software.
To display information about an extended Multiprotocol Label Switching (MPLS) ATM interface
co
ntrolled through the Virtual Switch Interface (VSI) protocol (or, if an interface is not specified, to
display information about all extended MPLS ATM interfaces controlled through the VSI protocol), use
the show controllers xtagatm command in user EXEC or privileged EXEC mode.
show controllers xtagatm i
f-number
Syntax Description
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Usage Guidelines Per-interface information includes the following:
• Interface name
• Physical descriptor
• Interface status
• Physical interface state (supplied by the switch)
• Acceptable VPI and VCI ranges
• Maximum cell rate
• Available cell rate (forward/backward)
• Available channels
Similar information appears if you enter the sho
w controllers vsi descriptor command. However, you
must specify an interface by its (switch-supplied) physical descriptor, instead of its Cisco IOS interface
na
me. For the Cisco BPX switch, the physical descriptor has the form slot.port.0.
Examples In this example, the sample output is from the show
controllers xtagatm command specifying interface
0:
Router# show controllers xtagatm 0
if-number Specifies the interface number.
Release Modification
12.0(5)T This command was introduced.
12.4(20)T This command was removed.