Specifications

show interface xtagatm
MP-456
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
138 packets input, 9193 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 i
00:05:46: %SYS-5-CONFIG_I: Configured from console by consolegnored, 0 abort
142 packets output, 19686 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
The following is sample command output when an interface is up:
Router# show interface xt92
XTagATM92 is up, line protocol is up
Hardware is Tag-Controlled Switch Port
Interface is unnumbered. Using address of Loopback1 (15.15.15.15)
MTU 4470 bytes, BW 4240 Kbit, DLY 80 used,
reliability 174/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive set (10 sec)
Encapsulation(s): AAL5
Control interface: ATM3/0, switch port: bpx 9.2
3 terminating VCs, 7 switch cross-connects
Switch port traffic:
275 cells input, 273 cells output
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
Terminating traffic:
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
127 packets input, 8537 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
131 packets output, 18350 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Table 25 describes the significant fields shown in the displays.
Ta b l e 25 show interface xtagatm Field Descriptions
Field Description
XTagATM0 is up
XTagATM0 is down
Interface is currently active (up) or inactive (down).
line protocol is up
line protocol is down
Displays the line protocol as up or down.
Hardware is
T
ag-Controlled Switch
Port
Specifies the hardware type.
Interface is unnumbered Specifies that this is an unnumbered interface.
MTU Maximum transmission unit of the extended MPLS ATM interface.
BW Bandwidth of the interface (in kBps).
DLY Delay of the interface in microseconds.