Specifications

Multiprotocol Label Switching Commands
append-after
MP-8
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
append-after
To insert a path entry after a specified index number, use the append-after command in IP explicit path
configuration mode.
append-after i
ndex command
Syntax Description
Defaults No path entry is inserted after a specified index number.
Command Modes IP explicit path configuration
Command History
Examples In the following example, the next
-address command is inserted after index 5:
Router(config-ip-expl-path)# append-after 5 next-address 10.3.27.3
Related Commands
index Previous index number. Valid values are from 0 to 65534.
command An IP explicit path configuration command that creates a path entry. (Use
th
e next-address command to specify the next IP address in the explicit
path.)
Release Modification
12.0(5)S This command was introduced.
12.1(3)T This command was integrated into Cisco IOS Release 12.1(3)T.
12.0(10)ST This command was integrated into Cisco IOS Release 12.0(10)ST.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
index Inserts or modifies a path entry at a specific index.
interface fastethernet Enters the command mode for IP explicit paths and creates or modifies the
s
pecified path.
list Displays all or part of the explicit paths.
next-address Specifies the next IP address in the explicit path.
show ip explicit-paths Displays the configured IP explicit paths.