Specifications

show interface xtagatm
MP-459
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Related Commands
output errors Sum of all errors that prevented the final transmission of datagrams out of
the interface being examined. Note that this may not balance with the sum
of the enumerated output errors, because some datagrams may have more
than one error, and others may have errors that do not fall into any of the
specifically tabulated categories.
collisions Number of messages re-sent due to an Ethernet collision. This is usually the
re
sult of an overextended LAN (Ethernet or transceiver cable too long, more
than two repeaters between stations, or too many cascaded multiport
transceivers). A packet that collides is counted only one time in output
packets.
interface resets Number of times an interface has been completely reset. Resets occur if
pa
ckets queued for transmission were not sent within several seconds. On a
serial line, this can be caused by a malfunctioning modem that is not
supplying the transmit clock signal, or by a cable problem. If the system
notices that the carrier detect line of a serial interface is up, but the line
protocol is down, it periodically resets the interface in an effort to restart it.
Interface resets can also occur when an interface is looped back or shut
down.
Table 25 show interface xtagatm Field Descriptions
Field Description
Command Description
interface xtagatm Enters configuration mode for an extended MPLS ATM (XTagATM)
in
terface.