Specifications

show ip route
MP-495
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Usage Guidelines The show ip route static download command provides a way to display all dynamic static routes with
name and distance information, including active and inactive ones. You can display all active dynamic
static routes with both the show ip route and show ip route static commands after these active routes
are added in the main routing table.
Examples
Routing Table Examples
The following examples show the standard routing tables displayed by the show ip route command. Use
the codes displayed at the beginning of each report and the information in Table 45 to understand the
type of route.
The following is sample output from the show
ip route command when entered without an address:
Router# show ip route
Codes: R - RIP derived, O - OSPF derived,
C - connected, S - static, B - BGP derived,
* - candidate default route, IA - OSPF inter area route,
i - IS-IS derived, ia - IS-IS, U - per-user static route,
o - on-demand routing, M - mobile, P - periodic downloaded static route,
D - EIGRP, EX - EIGRP external, E1 - OSPF external type 1 route,
E2 - OSPF external type 2 route, N1 - OSPF NSSA external type 1 route,
N2 - OSPF NSSA external type 2 route
Gateway of last resort is 10.119.254.240 to network 10.140.0.0
O E2 10.110.0.0 [160/5] via 10.119.254.6, 0:01:00, Ethernet2
E 10.67.10.0 [200/128] via 10.119.254.244, 0:02:22, Ethernet2
O E2 10.68.132.0 [160/5] via 10.119.254.6, 0:00:59, Ethernet2
O E2 10.130.0.0 [160/5] via 10.119.254.6, 0:00:59, Ethernet2
E 10.128.0.0 [200/128] via 10.119.254.244, 0:02:22, Ethernet2
11.3 The output from the show ip route ip-address command was enhanced to
display the origination of an IP route in Intermediate System-to-Intermediate
System (IS-IS) networks.
12.0(1)T The “M—mobile” code was added to the command output.
12.0(3)T The “P
—periodic downloaded static route” code was added to the command
output.
12.0(4)T The “ia
—IS-IS” code was added to the command output.
12.2(2)T The output from the sho
w ip route ip-address command was enhanced to
display information on the multipaths to the specified network.
12.2(13)T The eg
p and igrp arguments were removed because the exterior gateway
protocol (EGP) and the Interior Gateway Routing Protocol (IGRP) are no
longer available in Cisco IOS software.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(14)SX This command was integrated into Cisco IOS Release 12.2(14)SX.
12.3(2)T The output was enhanced to display route tag information.
12.3(8)T The output was enhanced to display static routes using DHCP.
12.2(27)SBC This command was integrated into Cisco IOS Release 12.2(27)SBC.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
Release Modification