Specifications

show ip rsvp fast detail
MP-509
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Bkup FilerSpec:
Tun Sender: 555.5.6.5, LSP ID: 8
Path ID handle: 04000405.
Incoming policy: Accepted. Policy source(s): MPLS/TE
Status: Proxied
Output on POS2/0. Policy status: Forwarding. Handle: 02000406
Table 50 describes the significant fields shown in the display.
Ta b l e 50 show ip rsvp fast detail Field Descriptions
Field Description
Tun Dest IP address of the receiver.
Tun ID Tunnel identification number.
Ext Tun ID Extended tunnel identification number.
Tun Sender IP address of the sender.
LSP ID Label-switched path identification number.
Setup Prio Setup priority.
Holding Prio Holding priority.
Flags Backup bandwidth protection has been configured for the
lab
el-switched path (LSP).
Session Name Name of the session.
ERO (incoming) EXPLICIT_ROUTE object of incoming path messages.
ERO (outgoing) EXPLICIT_ROUTE object of outgoing path messages.
Traffic params Rate Average rate, in bits per second.
Max. burst Maximum burst size, in bytes.
Min Policed Unit Minimum policed units, in bytes.
Max Pkt Size Maximum packet size, in bytes.
Inbound FRR Status of inbound Fast Reroute (FRR) backup tunnel. If this node is
d
ownstream from a rerouted LSP (for example, at a merge point for
th
is LSP), the state is Active.
Outbound FRR Status of outbound FRR backup tunnel. If this node is a point of local
r
epair (PLR) for an LSP, there are three possible states:
• Active—This LSP is actively using its backup tunnel, presumably
because there has been a downstream failure.
• No Backup—This LSP does not have local (Fast Reroute)
protection. No backup tunnel has been selected for it to use in case
of a failure.
• Ready—This LSP is ready to use a backup tunnel in case of a
downstream link or node failure. A backup tunnel has been
selected for it to use.