Specifications

show ip rsvp host
MP-539
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
In the following example from the show ip rsvp host senders command, an RSVP identity is configured
for the local sender and more information displays:
Router# show ip rsvp host senders
To From Pro DPort Sport Prev Hop I/F BPS
192.168.104.3 192.168.104.1 UDP 1 1 10K
Mode(s): Host CLI
Identity: voice100
Locator: GUID=www.cisco.com,APP=voice,VER=100.0
ID Type: Application
Table 66 describes the significant fields shown in the display.
DPort Destination port number. Code 1 indicates IP protocol such as
T
CP or UDP.
Sport Source port number. Code 1 indicates IP protocol such as TCP
or U
DP.
Prev Hop IP address of the previous hop. Blank means no previous hop.
I/F Interface of the previous hop.
BPS Reservation rate, in bits per second (bps).
Mode(s) Any of the following strings:
• Host—The router is acting as the host system or RSVP
endpoint for this reservation.
• LSP-Tunnel—The reservation is for a Traffic Engineering
(TE) tunnel.
• MIB—The reservation was created via an SNMP SET
directive from a remote management station.
• CLI—The reservation was created via a local RSVP CLI
command.
• Host CLI—A combination of the host and CLI strings
meaning that the static sender being displayed was created
by the ip rsvp sender-host CLI command.
Table 65 show ip rsvp host senders (No RSVP Identities Configured) Field Descriptions
Field Description
Ta b l e 66 show ip rsvp host senders (RSVP Identity Configured) Field Descriptions
Field Description
To IP address of the receiver.
From IP address of the sender.
Pro Protocol code. IP protocol such as TCP or UDP.
DPort Destination port number. Code 1 indicates IP protocol such as
T
CP or UDP.
Sport Source port number. Code 1 indicates IP protocol such as TCP
or U
DP.
Prev Hop IP address of the previous hop. Blank means no previous hop.