Specifications

show ip rsvp interface detail
MP-541
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show ip rsvp interface detail
To display the interface configuration for Hello, use the show ip rsvp interface detail command in
privileged EXEC mode.
show ip rsvp interface detail [in
terface]
Syntax Description
Command Default The interface configuration for Hello is not displayed.
Command Modes Privileged EXEC
Command History
Examples The following is sample output from the s
how ip rsvp interface detail command:
Router# show ip rsvp interface detail GigabitEthernet 9/47
Gi9/47:
RSVP: Enabled
Interface State: Up
Bandwidth:
Curr allocated: 0 bits/sec
Max. allowed (total): 0 bits/sec
Max. allowed (per flow): 0 bits/sec
Max. allowed for LSP tunnels using sub-pools (pool 1): 0 bits/sec
Set aside by policy (total): 0 bits/sec
Signalling:
DSCP value used in RSVP msgs: 0x3F
Number of refresh intervals to enforce blockade state: 4
Authentication: disabled
Key chain: <none>
Type: md5
Window size: 1
Challenge: disabled
FRR Extension:
Backup Path: Configured (or "Not Configured")
BFD Extension:
State: Disabled
Interval: Not Configured
RSVP Hello Extension:
State: Disabled
interface (Optional) Interface for which you want to show the Hello configuration.
Release Modification
12.0(22)S This command was introduced.
12.2(18)SXD1 This command was integrated into Cisco IOS Release 12.2(18)SXD1.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(31)SB2 This command was integrated into Cisco IOS Release 12.2(31)SB2.
12.2(33)SRC This command was integrated into Cisco IOS Release 12.2(33)SRC.