Specifications

show ip traffic-engineering configuration
MP-546
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show ip traffic-engineering configuration
To display information about configured traffic engineering filters and routes, use the show ip
traffic-engineering configuration command in privileged EXEC mode.
show ip traffic-engineering configuration [in
terface] [filter-number] [detail]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The sample output can show all filters or can be limited by interface, filter number, or both.
Examples The following is sample output from the show
ip traffic-engineering configuration detail command:
Router# show ip traffic-engineering configuration detail
Traffic Engineering Configuration
Filter 5: egress 44.0.0.0/8, local metric: ospf-0/1
Tunnel5 route installed
interface up, preference 1
loop check on, passing, remote metric: connected/0
Filter 6: egress 43.0.0.1/32, local metric: ospf-300/3
Tunnel7 route installed
interface up, preference 50
loop check on, passing, remote metric: ospf-300/2
Tunnel6 route not installed
interface up, preference 75
loop check on, passing, remote metric: connected/0
interface (Optional) Specifies an interface for which to display traffic engineering
information.
filter-number (Optional) A decimal value representing the number of the filter to display.
detail (Optional) Displays command output in long form.
Release Modification
11.1CT This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.