Specifications

show isis mpls traffic-eng tunnel
MP-563
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show isis mpls traffic-eng tunnel
To display information about tunnels considered in the Intermediate System-to-Intermediate System
(IS-IS) next hop calculation, use the show isis mpls traffic-eng tunnel command in privileged EXEC
mode.
show isis mpls traffic-eng tunnel
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Examples The following is sample output from the sho
w isis mpls traffic-eng tunnel command:
Router# show isis mpls traffic-eng tunnel
Station Id Tunnel Name Bandwidth Nexthop Metric Mode
kangpa-router1.00 Tunnel1022 3333 10.2.2.2 -3 Relative
Tunnel1021 10000 10.2.2.2 11 Absolute
tomklong-route.00 Tunnel1031 10000 172.17.3.3 -1 Relative
Tunnel1032 10000 172.17.3.3
Table 79 describes the significant fields shown in the display.
Release Modification
12.0(5)S This command was introduced.
12.1(3)T This command was integrated into Cisco IOS Release 12.1(3)T.
12.0(10)ST This command was integrated into Cisco IOS Release 12.0(10)ST.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Ta b l e 79 show isis mpls traffic-eng tunnel Field Descriptions
Field Description
Station Id Name or system ID of the MPLS traffic engineering tailend router.
Tunnel Name Name of the MPLS traffic engineering tunnel interface.
Bandwidth MPLS traffic engineering specified bandwidth of the tunnel.
Nexthop MPLS traffic engineering destination IP address of the tunnel.
Metric MPLS traffic engineering metric of the tunnel.
Mode MPLS traffic engineering metric mode of the tunnel. It can be
r
elative or absolute.