Specifications

show mpls interfaces
MP-605
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
The following is sample output from the show mpls interfaces command with the internal keyword.
The output shows whether MPLS egress NetFlow accounting is enabled on the interface. If MPLS egress
NetFlow accounting is disabled, the Output_feature_state field displays 0x0. If MPLS egress Netflow
accounting is enabled, the Output_feature_state field is any number, except 0x0.
Router# show mpls interfaces internal
Interface Ethernet0/0/1:
IP labeling enabled (tdp)
LSP Tunnel labeling not enabled
MPLS operational
IP to Tag Fast Feature Switching Vector
MPLS turbo vector
MTU = 1500, status=0x100043, appcount=1
Output_feature_state=0x0
Interface Ethernet0/0/2:
IP labeling enabled (tdp)
LSP Tunnel labeling not enabled
MPLS operational
IP to Tag Fast Feature Switching Vector
MPLS turbo vector
MTU = 1500, status=0x100043, appcount=1
Output_feature_state=0x1
Related Commands Command Description
mpls ip (global
conf
iguration)
Enables MPLS forwarding of IPv4 packets along normally routed paths for
the platform.
mpls ip (interface
conf
iguration)
Enables MPLS forwarding of IPv4 packets along normally routed paths for
a particular interface.
mpls label protocol
(
global configuration)
Specifies the default label distribution protocol for a platform.
mpls label protocol
(i
nterface
configuration)
Specifies the label distribution protocol to be used on a given interface.
mpls traffic-eng
t
unnels (global
configuration)
Enables MPLS traffic engineering tunnel signaling on a device.
mpls traffic-eng
t
unnels (interface
configuration)
Enables MPLS traffic engineering tunnel signaling on an interface.