Specifications

show mpls l2transport checkpoint
MP-631
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls l2transport checkpoint
To display checkpointing information about Any Transport over MPLS (AToM) virtual circuits (VCs),
use the show mpls l2transport checkpoint command in privileged EXEC mode.
show mpls l2transport checkpoint
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC (#)
Command History
Examples The output of the commands varies, depending on whether the output reflects the active or standby Route
P
rocessor (RP).
On the active RP, the command displays the following output:
Router# show mpls l2transport checkpoint
AToM Checkpoint info for active RP
Checkpointing is allowed
Bulk-sync checkpointed state for 1 VC
On the standby RP, the command displays the following output:
Router# show mpls l2transport checkpoint
AToM HA Checkpoint info for standby RP
1 checkpoint information block in use
In general, the output on the active RP shows that checkpointing information was sent to the backup RP.
The output on the backup RP shows that checkpointing information was received from the active RP.
Related Commands
Release Modification
12.2(25)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
12.2(33)SRC This command was integrated into Cisco IOS Release 12.2(33)SRC.
12.2(33)SCC This command was integrated into Cisco IOS Release 12.2(33)SCC.
Command Description
show mpls l2transport vc Displays information about the checkpointed data when checkpointing is
ena
bled.