Specifications

show mpls l2transport vc
MP-640
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
The following example shows information about the NSF, SSO, and graceful restart capability. The SSO
portion indicates when checkpointing data has either been sent (on active) or received (on standby).
When SSO data has not been successfully sent or has been released, the SSO information is not shown.
Router# show mpls l2transport vc detail
Local interface: Fa5/1/1.2 down, line protocol down, Eth VLAN 2 up
Destination address: 10.55.55.2, VC ID: 1002, VC status: down
Output interface: Se4/0/3, imposed label stack {16}
Preferred path: not configured
Default path: active
Tunnel label: imp-null, next hop point2point
Create time: 02:03:29, last status change time: 02:03:26
Signaling protocol: LDP, peer 10.55.55.2:0 down
MPLS VC labels: local 16, remote unassigned
Group ID: local 0, remote unknown
MTU: local 1500, remote unknown
Remote interface description:
Sequencing: receive disabled, send disabled
SSO Descriptor: 10.55.55.2/1002, local label: 16
SSM segment/switch IDs: 12290/8193, PWID: 8193
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, send 0
Table 105 to Table 109 describes the fields shown in the display.
The following example shows information provided when an AToM static pseudowire has been
pr
ovisioned and the show mpls l2transport vc detail command is used to check the configuration. The
Signaling protocol field specifies Manual, because a directed control protocol such as Label Distribution
Protocol (LDP) cannot be used to exchange parameters on static pseudowires. The remote interface
description field seen for nonstatic pseudowire configurations is not displayed, because remote
information is exchanged using signaling between the PE routers and this is not done on static
pseudowires.
Router# show mpls l2transport vc detail
Local interface: Et1/0 up, line protocol up, Ethernet up
Destination address: 10.1.1.2, VC ID: 100, VC status: up
Output interface: Et2/0, imposed label stack {10003 150}
Preferred path: not configured
Default path: active
Next hop: 10.0.0.2
Create time: 00:18:57, last status change time: 00:16:10
Signaling protocol: Manual
MPLS VC labels: local 100, remote 150
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 219, send 220
byte totals: receive 20896, send 26694
packet drops: receive 0, send 0
Table 105 to Table 109 describes the fields shown in the display.
The following example shows the VC statistics displaying the number of packets and bytes being sent
f
rom the router. The VC statistics fields include the word “transit” to show that the packet totals no
longer include packets being sent to the router.