Specifications

show mpls l2transport vc
MP-644
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Table 107 describes the fields shown in the display.
The following example shows sample output from the show
mpls l2 transport vc command when the
CEM interface is specified.
Router# show mpls l2transport vc interface CEM 3/1/1
Local intf Local circuit Dest address VC ID Status
---------- ------------- ------------ ----- ------
CE3/1/1 CESOPSN Basic 10.30.30.3 300 DOWN
Table 105 to Table 109 describes the fields shown in the display.
The following example displays (in bold) the number of MAC address withdrawal messages sent and
r
eceived as part of the H-VPLS N-PE Redundancy for QinQ and MPLS Access feature:
Router# show mpls l2transport vc detail
Local interface: VFI TEST VFI up
MPLS VC type is VFI, interworking type is Ethernet
Destination address: 10.1.1.1, VC ID: 1000, VC status: up
Output interface: Se2/0, imposed label stack {17}
Preferred path: not configured
Default path: active
Next hop: point2point
Create time: 00:04:34, last status change time: 00:04:15
Signaling protocol: LDP, peer 10.1.1.1:0 up
Targeted Hello: 10.1.1.1(LDP Id) -> 10.1.1.1
MPLS VC labels: local 16, remote 17
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
MAC Withdraw: sent 5, received 3
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 0, send 0
byte totals: receive 0, send 0
packet drops: receive 0, send 0
Table 105 to Table 109 describes the fields shown in the display.
The following example displays (in bold) the status messages for the MPLS Pseudowire Status Signaling
f
eature when it is enabled on both PE routers:
Router# show mpls l2transport vc detail
Local interface: Et1/0 up, line protocol up, Ethernet up
Destination address: 10.1.1.1, VC ID: 456, VC status: up
Output interface: Et2/0, imposed label stack {10005 10240}
Preferred path: not configured
Ta b l e 107 show mpls l2transport vc detail Field Descriptions for VPLS Autodiscovery
Field Description
Next hop PE address The IP address of the next hop router.
AGI The attachment group identifier (AGI).
Local AII The attachment individual identifier (AII). The local IP address used for
si
gnaling.
Remote AII The remote IP address used for signaling. This address is the provisioned IP
a
ddress, which might not be the same as the LDP peer IP address.