Specifications

show mpls l2transport vc
MP-646
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
The following example shows sample output from the show mpls l2 transport vc command to display
the status of multisegment pseudowires.
PE1# show mpls l2transport vc detail
Local interface: Se3/0 up, line protocol up, HDLC up
Destination address: 12.1.1.1, VC ID: 100, VC status: down
Output interface: Se2/0, imposed label stack {23}
Preferred path: not configured
Default path: active
Next hop: point2point
Create time: 00:03:02, last status change time: 00:01:41
Signaling protocol: LDP, peer 12.1.1.1:0 up
Targeted Hello: 11.1.1.1(LDP Id) -> 12.1.1.1, LDP is UP
Status TLV support (local/remote) : enabled/supported
LDP route watch : enabled
Label/status state machine : established, LruRrd
Last local dataplane status rcvd: No fault
Last local SSS circuit status rcvd: No fault
Last local SSS circuit status sent: DOWN(PW-tx-fault)
Last local LDP TLV status sent: No fault
Last remote LDP TLV status rcvd: DOWN(PW-tx-fault)
PW Switching Point:
Fault type Vcid local IP addr remote IP addr Description
PW-tx-fault 101 13.1.1.1 12.1.1.1 S-PE2
Last remote LDP ADJ status rcvd: No fault
MPLS VC labels: local 19, remote 23
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
VC statistics:
packet totals: receive 16, send 27
byte totals: receive 2506, send 3098
packet drops: receive 0, seq error 0, send 0
Table 109 describes the fields shown in the display.
Last local LDP TLV
st
atus sent
The last status message sent about the Type, Length, Value (TLV) on the
local router.
Last remote LDP TLV
s
tatus rcvd
The last status message received about the TLV on the local router.
Table 108 show mpls l2transport vc detail Field Descriptions for the MPLS Pseudowire
Signaling Status Feature
Field Description
Ta b l e 109 show mpls l2transport vc detail Field Descriptions for the MPLS Multisegment
Pseudowire Feature
Field Description
Fault type Type of fault encountered on the switching point.
Vcid The ID of the VC where the fault occurred.
local IP addr The local IP address of the pseudowire.
remote IP addr The remote IP address of the pseudowire.
Description The descriptions assigned to the segment of the pseudowire.