Specifications

show mpls ldp neighbor password
MP-678
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls ldp neighbor password
To display password information used in established Label Distribution Protocol (LDP) sessions, use the
show mpls ldp neighbor password command in user EXEC mode or privileged EXEC mode.
show mpls ldp neighbor [vr
f vrf-name] [ip-address | interface] password [pending | current] [all]
Syntax Description
Defaults If you do not specify an optional keyword for this command, password information for all established
L
DP sessions is displayed.
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines Use this command to display password information for established LDP sessions. If you do not specify
an
option, password information for all established LDP sessions is displayed. To display LDP sessions
whose password is the same as that in the current configuration, use the current keyword with the
command. To display LDP sessions whose password is different from that in the current configuration,
use the pending keyword with the command.
vrf vr
f-name (Optional) Displays the LDP neighbors for the specified Virtual Private Network
(VPN) routing and forwarding (VRF) instance.
ip-address (Optional) Identifies the neighbor that has this IP address.
interface (Optional) Identifies the LDP neighbors accessible over this interface.
pending (Optional) Displays LDP sessions whose password is different from that in the
cu
rrent configuration.
current (Optional) Displays LDP sessions whose password is the same as that in the current
co
nfiguration.
all (Optional) When the al
l keyword is specified alone in this command, the command
displays LDP password information for all neighbors in all VPNs, including those in
the global routing table.
Release Modification
12.2(28)SB This command was introduced.
12.0(32)SY This command was integrated into Cisco IOS Release 12.0(32)SY.
12.2(33)SRB This command was integrated into Cisco IOS Release 12.2(33)SRB.
12.0(33)S This command was integrated into Cisco IOS Release 12.0(33)S.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.