Specifications

show mpls platform
MP-685
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls platform
To display platform-specific information, use the show mpls platform command in EXEC mode.
show mpls platform {c
ommon | eompls | gbte-tunnels | reserved-vlans vlan vlan-id | statistics
[reset] | vpn-vlan-mapping}
Syntax Description
Defaults This command has no default settings.
Command Modes EXEC
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
En
gine 2.
Examples This example shows how to display the counters for shared code between the LAN and WAN interfaces:
Router# show mpls platform common
Common MPLS counters for LAN and WAN
-------------------------------------
No. of MPLS configured LAN interfaces = 12
No. of cross-connect configured VLAN interfaces = 0
Router#
common Displays the counters for shared code between the LAN and WAN
interfaces.
eompls Displays information about the Ethernet over Multiprotocol Label
S
witching (EoMPLS)-enabled interface.
gbte-tunnels Displays information about the Multicast Multilayer Switching (MMLS)
G
uaranteed Bandwidth Traffic Engineering (GBTE) tunnels.
reserved-vlans vlan
vla
n-id
Displays Route Processor (RP)-reserved VLAN show commands; valid
values are from 0 to 4095.
statistics Displays information about the RP-control plane statistics.
reset (Optional) Resets the statistics counters.
vpn-vlan-mapping Displays information about the Virtual Private Network (VPN)-to-VLAN
ma
pping table.
Release Modification
12.2(17b)SXA Support for this command was introduced on the Supervisor Engine 720.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.