Specifications

show mpls traffic tunnel backup
MP-694
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls traffic tunnel backup
To display information about the backup tunnels that are currently configured, use the show mpls traffic
tunnel backup command in user EXEC or privileged EXEC mode.
show mpls traffic tunnel backup t
unneltunnel-id
Syntax Description
Command Default Information about currently configured backup tunnels is not displayed.
Command Modes User EXEC
Privileged EXEC
Command History
Examples The following is sample output from the show mpls t
raffic tunnel backup tunnel tunnel-id command:
Router# show mpls traffic tunnel backup tunnel1000
Tunnel1000 Dest: 10.0.0.9 State: Up
any-pool cfg 100 inuse 0 num_lsps 0
protects: ATM0.1
Table 123 describes the significant fields shown in the display.
tunneltu
nnel-id Tunnel ID of the backup tunnel for which you want to display information.
Release Modification
12.0(22)S This command was introduced.
12.2(18)SXD1 This command was integrated into Cisco IOS Release 12.2(18)SXD1.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T
Ta b l e 123 show mpls traffic tunnel backup Field Descriptions
Field Description
Tunnel Tunnel ID of the backup tunnel for which this information is being
d
isplayed.
Dest IP address of the destination of the backup tunnel.
State State of the backup tunnel. Valid values are Up, Down, or
A
dmin-down.
any-pool Pool from which bandwidth is acquired. Valid values are any-pool,
gl
obal-pool, and sub-pool.
cfg Amount of bandwidth configured for that pool.
inuse Amount of bandwidth currently being used.