Specifications

show mpls traffic-eng autoroute
MP-696
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls traffic-eng autoroute
To display tunnels announced to the Interior Gateway Protocol (IGP), including interface, destination,
and bandwidth, use the show mpls traffic-eng autoroute command in user EXEC or privileged EXEC
mode.
show mpls traffic-eng autoroute
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines The enhanced shortest path first (SPF) calculation of t
he IGP has been modified so that it uses traffic
engineering tunnels. This command shows which tunnels IGP is currently using in its enhanced SPF
calculation (that is, which tunnels are up and have autoroute configured).
Examples The following is sample output from the s
how mpls traffic-eng autoroute command.
Note that the tunnels are organized by destination. All tunnels to a destination carry a share of the traffic
tu
nneled to that destination.
Router# show mpls traffic-eng autoroute
MPLS TE autorouting enabled
destination 0002.0002.0002.00 has 2 tunnels
Tunnel1021 (traffic share 10000, nexthop 10.2.2.2, absolute metric 11)
Tunnel1022 (traffic share 3333, nexthop 10.2.2.2, relative metric -3)
destination 0003.0003.0003.00 has 2 tunnels
Tunnel1032 (traffic share 10000, nexthop 172.16.3.3)
Tunnel1031 (traffic share 10000, nexthop 172.16.3.3, relative metric -1)
Table 124 describes the significant fields shown in the display.
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.