Specifications

show mpls traffic-eng auto-tunnel mesh
MP-698
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls traffic-eng auto-tunnel mesh
To display the cloned mesh tunnel interfaces of each autotemplate interface and the current range of
mesh tunnel interface numbers, use the show mpls traffic-eng auto-tunnel mesh command in user
EXEC mode or privileged EXEC mode.
show mpls traffic-eng auto-tunnel mesh
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC (>)
Privileged EXEC (#)
Command History
Examples The following is output from the show mpls t
raffic-eng auto-tunnel mesh command that shows the
cloned mesh tunnel interfaces for autotemplate1 and shows the range of mesh tunnel interface numbers.
Information for only one autotemplate is displayed because only one autotemplate was configured.
Router# show mpls traffic-eng auto-tunnel mesh
Auto-Template1:
Using access-list 1 to clone the following tunnel interfaces:
Destination Interface
----------- ---------
10.2.2.2 Tunnel64336
10.3.3.3 Tunnel64337
Mesh tunnel interface numbers: min 64336 max 65337
Table 125 describes the significant fields shown in the display.
Release Modification
12.0(27)S This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Ta b l e 125 show mpls traffic-eng auto-tunnel mesh Field Descriptions
Field Description
Auto-Template1 Name of the autotemplate.
Destination Destination addresses for the mesh tunnel interface cloned
fro
m access list 1.