Specifications

show mpls traffic-eng link-management admission-control
MP-714
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
show mpls traffic-eng link-management admission-control
To show which tunnels were admitted locally and their parameters (such as, priority, bandwidth,
incoming and outgoing interface, and state), use the show mpls traffic-eng link-management
admission-control command in user EXEC or privileged EXEC mode.
show mpls traffic-eng link-management admission-control [in
terface-name]
Syntax Description
Command Modes User EXEC
Privileged EXEC
Command History
Examples The following is sample output from the show mpls t
raffic-eng link-management admission-control
command:
Router # show mpls traffic-eng link-management admission-control
System Information::
Tunnels Count: 4
Tunnels Selected: 4
TUNNEL ID UP IF DOWN IF PRIORITY STATE BW (kbps)
10.106.0.6 1000_1 AT1/0.2 - 0/0 Resv Admitted 0
10.106.0.6 2000_1 Et4/0/1 - 1/1 Resv Admitted 0
10.106.0.6 1_2 Et4/0/1 Et4/0/2 1/1 Resv Admitted 3000 R
10.106.0.6 2_2 AT1/0.2 AT0/0.2 1/1 Resv Admitted 3000 R
Table 133 describes the significant fields shown in the display.
interface-name (Optional) Displays only tunnels that were admitted on the specified
i
nterface.
Release Modification
12.0(5)S This command was introduced.
12.1(3)T The command output changed. The BW field now shows bandwidth in
k
Bps, and it is followed by the status (reserved or held) of the bandwidth.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Ta b l e 133 show mpls traffic-eng link-management admission-control Field Descriptions
Field Description
Tunnels Count Total number of tunnels admitted.
Tunnels Selected Number of tunnels to be displayed.
TUNNEL ID Tunnel identification.