Specifications

Multiprotocol Label Switching Commands
clear mpls ldp checkpoint
MP-36
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
clear mpls ldp checkpoint
To clear the checkpoint information from the Label Information Base (LIB) entries on the active Route
Processor (RP) or PRE and to clear the LIB entries created by checkpointing on the standby RP or PRE,
use the clear mpls ldp checkpoint command in privileged EXEC mode.
clear mpls ldp checkpoint [vr
f vpn-name] {network {mask | length} [longer-prefixes] | *}
[incomplete]
Cisco 10000 Series Routers
clear mpls ldp checkpoint {network {mask | length} [longer-prefixes] | *} [incomplete]
Syntax Description
Defaults Checkpoint information resides on the active and standby RP.
Command Modes Privileged EXEC
Command History
Usage Guidelines Use this command only when Cisco support personnel recommend it as a means of rectifying a problem.
On the active RP o
r PRE, this command does the following:
• Clears the checkpoint state information from the specified LIB entries.
• Triggers a checkpoint attempt for those entries.
On the standby RP
or PRE, this command deletes all of the LIB entries created by checkpointing.
vrf vp
n-name (Optional) Clears the checkpoint information for the specified VPN routing
and forwarding (VRF) instance (vpn-name).
Note Applies to the Cisco 7000 series routers only.
network Clears the checkpoint information for the specified destination address.
mask Specifies the network mask, written as A.B.C.D.
length Specifies the mask length.
longer-prefixes (Optional) Clears the checkpoint information for any prefix that matches
ma
sk with the length specified.
* (Optional) Clears the checkpoint information for all destinations.
incomplete (Optional) Clears any incomplete checkpoint information from the LIB.
Release Modification
12.2(25)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB and
i
mplemented on the Cisco 10000 series routers.