Specifications

show mpls traffic-eng tunnels
MP-750
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Related Commands
STATE/PROT For tunnel heads, admin-down, up, or down. For nonheads,
signaled.
Adjustment threshold Configured threshold. This field is displayed only if a
t
hreshold is explicitly configured.
Overflow Limit
Overflow Threshold
Resized the tunnel before the end of the sampling interval if
t
he output rate exceeded the current bandwidth by the percent
specified in the overflow threshold the number of times
specified in the overflow limit. These fields are displayed
only if an overflow limit was specified in the tunnel mpls
traffic-eng auto-bw command.
Overflow Threshold Crossed Number of times the output rate exceeded the overflow
t
hreshold in consecutive collection intervals. This value is
reset at the beginning of the automatic bandwidth sampling
interval.
Number of Auto-bw Adjustment resize
r
equests
Number of times the tunnel was resized because an output
rate exceeded the adjustment threshold. This field is
displayed only if the number is greater than zero and if
automatic bandwidth is enabled on the tunnel. This counter is
reset each time automatic bandwidth is enabled on the tunnel.
You can clear this counter at any time by entering the clear
mpls traffic-eng auto-bw timer command.
Time since last Auto-bw Adjustment
res
ize request
The amount of time (in minutes and seconds) since the last
bandwidth adjustment.
Number of Auto-bw Overflow resize
r
equests
The number of times (in seconds) the tunnel was resized
because an overflow limit was exceeded. This field is
displayed only if the number is greater than zero and if an
overflow limit is enabled on the tunnel. This counter is reset
each time automatic bandwidth is enabled on the tunnel. You
can clear this counter at any time by entering the clear mpls
traffic-eng auto-bw timer command.
Time since last Auto-bw Overflow
res
ize request
The amount of time (in seconds) since the tunnel was resized
because an overflow limit was exceeded.
Table 148 show mpls traffic-eng tunnels Field Descriptions (continued)
Field Description
Command Description
mpls traffic-eng reoptimize timers
f
requency
Controls the frequency with which tunnels with established
LSPs are checked for better LSPs.
mpls traffic-eng tunnels
(
configuration)
Enables MPLS traffic engineering tunnel signaling on a
device.
mpls traffic-eng tunnels (interface) Enables MPLS traffic engineering tunnel signaling on an
in
terface.