Specifications

show xconnect
MP-775
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Table 155 describes the significant fields shown in the display.
The additional fields displayed in the detailed output are self-explanatory.
Ta b l e 155 show xconnect all Field Descriptions
Field Description
XC ST State of the xconnect attachment circuit or pseudowire. Valid states are:
• DN—The xconnect attachment circuit or pseudowire is down. Either segment 1,
segment 2, or both segments are down.
• IA—The xconnect attachment circuit or pseudowire is inactive. This state is valid
only when pseudowire redundancy is configured.
• NH—One or both segments of this xconnect no longer have the required hardware
resources available to the system.
• UP—The xconnect attachment circuit or pseudowire is up. Both segment 1 and
segment 2 must be up for the xconnect to be up.
Segment1
or
Segment2
Information about the type of xconnect, the interface type, and the IP address the segment
i
s using. Types of xconnects are as follows:
• ac—Attachment circuit
• l2tp—Layer 2 Tunnel Protocol
• mpls—Multiprotocol Label Switching
• pri ac—Primary attachment circuit
• sec ac—Secondary attachment circuit
S1
or
S2
State of the segment. Valid states are:
• AD—The segment is administratively down.
• DN—The segment is down.
• HS—The segment is in hot standby mode.
• RV—The segment is recovering from a graceful restart.
• SB—The segment is in a standby state.
• UP—The segment is up.