Specifications

Multiprotocol Label Switching Commands
clear mpls traffic-eng auto-bw timers
MP-40
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
clear mpls traffic-eng auto-bw timers
To reinitialize the automatic bandwidth adjustment feature on a platform, use the clear mpls traffic-eng
auto-bw timers command in user EXEC mode.
clear mpls traffic-eng auto-bw timers
Syntax Description This command has no arguments or keywords.
Defaults There are no defaults for this command.
Command Modes User EXEC
Command History
Usage Guidelines For each tunnel for which automatic bandwidth adjustment is enabled, the platform maintains
i
nformation about sampled output rates and the time remaining until the next bandwidth adjustment. The
clear mpls traffic-eng auto-bw timers command clears this information for all such tunnels. The effect
is as if automatic bandwidth adjustment had just been enabled for the tunnels.
Examples The following example shows how to clear information about sampled output rates and the time
re
maining until the next bandwidth adjustment:
Router# clear mpls traffic–eng auto–bw timers
Clear mpls traffic engineering auto-bw timers [confirm]
Release Modification
12.2(4)T This command was introduced.
12.2(11)S This command was integrated into Cisco IOS Release 12.2(11)S.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.