Specifications

show xtagatm cross-connect
MP-783
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
Conn-state Indicates the status of the cross-connect to which this endpoint belongs. The
cross-connect state is typically UP; other values, all of which are transient,
include the following:
• DOWN ABOUT_TO_DOWN ABOUT_TO_CONNECT
• CONNECTING
• ABOUT_TO_RECONNECT
• RECONNECTING
• ABOUT_TO_RESYNC
• RESYNCING
• NEED_RESYNC_RETRY
• ABOUT_TO_RESYNC_RETRY
• RETRYING_RESYNC
• ABOUT_TO_DISCONNECT
• DISCONNECTING
Conn-type Input—Indicates an ingress endpoint where traffic is only expected to be
r
eceived into the switch.
Output—Indicates an egress endpoint, where traffic is only expected to be
se
nt from the interface.
Input/output—Indicates that traffic is expected to be both send and received
at
this endpoint.
Cast-type Indicates whether the cross-connect is multicast.
Rx service type Quality of service type for the receive, or ingress, direction. This is MPLS
Qo
S <n>, (MPLS Quality of Service <n>), where n is in the range
from 0 to 7 for input and input/output endpoints; this will be N/A for output
e
ndpoints. (In the first release, this is either 0 or 7.)
Rx cell rate (Guaranteed) cell rate in the receive, or ingress, direction.
Rx peak cell rate Peak cell rate in the receive, or ingress, direction, in cells per second. This
i
s n/a for an output endpoint.
Tx service type Quality of service type for the transmit, or egress, direction. This is MPLS
Qo
S <n>, (MPLS Class of Service <n>), where n is in the range from 0 to 7
for
output and input/output endpoints; this will be N/A for input endpoints.
Tx cell rate (Guaranteed) cell rate in the transmit, or egress, direction.
Tx peak cell rate Peak cell rate in the transmit, or egress, direction, in cells per second. This
i
s N/A for an input endpoint.
Table 160 show xtagatm cross-connect descriptor Field Descriptions (continued)
Field Description