Specifications

snmp-server enable traps (MPLS)
MP-792
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
notification-type
(continued)
• mpls ldp—Sends notifications about status changes in LDP sessions. Note
that this keyword is specified as mpls ldp. This syntax, which the CLI
interprets as a two-word construct, has been implemented in this manner
to maintain consistency with other MPLS commands. Notification-option
arguments (below) can be specified in combination with this keyword.
• mpls traffic-eng—Sends notifications about status changes in MPLS
label distribution tunnels. This keyword is specified as mpls traffic-eng.
T
his syntax, which the CLI interprets as a two-word construct, has been
implemented in this manner to maintain consistency with other MPLS
commands. Notification-option arguments (below) can be specified in
combination with this keyword.
notification-option (Optional) Defines the particular options associated with the specified
n
otification-type that are to be enabled on the LSR.
• envmon [voltage | shutdown | supply | fan | temperature]
When you specify the en
vmon keyword, you can enable any one or all of
the following environmental notifications in any combination: voltage,
shutdown, supply, fan, or temperature. If you do not specify an
argument with the envmon keyword, all types of system environmental
notifications are enabled on the LSR.
• isdn [call-information | isdn u-interface]
When you specify the isdn ke
yword, you can use either the
call-information argument (to enable an SNMP ISDN call information
option for the ISDN MIB subsystem) or the i
sdn u-interface argument (to
enable an SNMP ISDN U interface option for the ISDN U Interfaces MIB
subsystem), or both. If you do not specify an argument with the isdn
keyword, both types of isdn notifications are enabled on the LSR.
• repeater [health | reset]
When you specify the re
peater keyword, you can use either the health
argument or the reset argument, or both (to enable the IETF Repeater Hub
MIB [RFC 1516] notification). If you do not specify an argument with the
repeater keyword, both types of notifications are enabled on the LSR.
• mpls ldp [session-up | session-down | pv-limit | threshold]
When you specify the mpl
s ldp keyword, you can use any one or all of the
following arguments in any combination to indicate status changes in LDP
sessions: session-up, session-down, pv-limit, or threshold. If you do not
specify an argument with the mpls ldp k
eyword, all four types of LDP
session notifications are enabled on the LSR.
• mpls traffic-eng [up | down | reroute]
When you specify the mpls
traffic-eng keyword, you can use any one or
all of the following arguments in any combination to enable the sending of
notifications regarding status changes in MPLS label distribution tunnels:
up, down, or reroute. If you do not specify an argument with the
mpls traffic-eng ke
yword, all three types of tunnel notifications are
enabled on the LSR.