Specifications

snmp-server enable traps mpls ldp
MP-795
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
snmp-server enable traps mpls ldp
To enable the sending of Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP)
Simple Network Management Protocol (SNMP) notifications, use the snmp-server enable traps mpls
ldp command in global configuration mode. To disable the sending of MPLS LDP notifications, use the
no form of this command.
snmp-server enable traps mpls ldp [pv
-limit] [session-down] [session-up] [threshold]
no s
nmp-server enable traps mpls ldp [pv-limit] [session-down] [session-up] [threshold]
Syntax Description
Command Default The sending of SNMP notifications is disabled. If you do not specify an optional keyword, all four types
o
f LDP notifications are enabled on the label switching router (LSR).
Command Modes Global configuration (config)
Command History
Usage Guidelines The MPLS LDP pv-limit (mplsLdpPathVectorLimitMismatch) notification provides a warning message
t
hat can be sent to the network management station (NMS) when two routers engaged in LDP operations
have a dissimilar path-vector limits.
The value of the path-vector limit can range from 0 to 255; a value of 0 indicates that loop detection is
of
f. Any value other than 0 up to 255 indicates that loop detection is on and specifies the maximum
number of hops through which an LDP message can pass before a loop condition in the network is
sensed.
pv-limit (Optional) Enables or disables path-vector (PV) limit notifications
(
mplsLdpPathVectorLimitMismatch).
session-down (Optional) Enables or disables LDP session down notifications
(mp
lsLdpSessionDown).
session-up (Optional) Enables or disables LDP session up notifications
(mp
lsLdpSessionUp).
threshold (Optional) Enables or disables PV Limit notifications
(mp
lsLdpFailedInitSessionThresholdExceeded).
Release Modification
12.0(21)ST This command was introduced.
12.2(13)T This command was integrated into Cisco IOS Release 12.2(13)T.
12.0(30)S This command was integrated into Cisco IOS Release 12.0(30)S.
12.2(27)SBC This command was integrated into Cisco IOS Release 12.2(27)SBC.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.