Specifications

snmp-server enable traps mpls rfc vpn
MP-801
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
snmp-server enable traps mpls rfc vpn
To enable the sending of Multiprotocol Label Switching (MPLS) Virtual Private Network (VPN) Simple
Network Management Protocol (SNMP) notifications defined in RFC 4382, use the s
nmp-server enable
traps mpls rfc vpn command in global configuration mode. To disable the sending of MPLS VPN
notifications, use the no form of this command
snmp-server enable traps mpls rfc vpn [i
llegal-label] [max-thresh-cleared] [max-threshold]
[mid threshold] [vrf-down] [vrf-up]
no snmp-server enable traps mpls rfc vpn [ille
gal-label] [max-thresh-cleared] [max-threshold]
[mid threshold] [vrf-down] [vrf-up]
Syntax Description
Command Default The sending of SNMP notifications is disabled by default.
Command Modes Global configuration (config)
Command History
Usage Guidelines If this command is used without any of the optional keywords, all MPLS RFC VPN notification types
ar
e enabled.
illegal-label (Optional) Enables or disables an MPLS RFC VPN notification for any
i
llegal labels received on a VPN routing and forwarding (VRF) instance
interface.
max-thresh-cleared (Optional) Enables or disables an MPLS RFC VPN notification when the
n
umber of routes attempts to exceed the maximum limit and then drops
below the maximum number of routes.
max-threshold (Optional) Enables or disables an MPLS RFC VPN notification when a route
cr
eation attempt was unsuccessful because the maximum route limit was
reached.
mid-threshold (Optional) Enables or disables an MPLS RFC VPN warning when the
n
umber of routes created has exceeded the warning threshold.
vrf-down (Optional) Enables or disables an MPLS RFC VPN notification when the last
i
nterface associated with a VRF transitions to the down state.
vrf-up (Optional) Enables or disables an MPLS RFC VPN notification when the
f
irst interface associated with a VRF transitions to the up state when
previously all interfaces were in the down state.
Release Modification
12.2(33)SRC This command was introduced.
12.2(33)SB This command was integrated into Cisco IOS Release 12.2(33)SB.