Specifications

tunnel destination list mpls traffic-eng
MP-845
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel destination list mpls traffic-eng
To specify a list of Multiprotocol Label Switching (MPLS) traffic engineering (TE) point-to-multipoint
(P2MP) destinations, use the tunnel destination list mpls traffic-eng command in interface
configuration mode. To remove the destination list, use the no form of this command.
tunnel destination list mpls traffic-eng {id
destination-list-number | name destination-list-name}
no tunnel destination list mpls traffic-eng {id d
est-list-number | name dest-list-name}
Syntax Description
Command Default No destination list is specified.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Use the t
unnel destination list mpls traffic-eng command to specify a list point-to-multipoint tunnels.
Examples The following example configures point-to-multipoint traffic engineering on tunnel interface 1:
Router# interface tunnel1
Router(config-if)# tunnel mode mpls traffic-eng point-to-multipo
int
Router(config-if)# tunnel destination list mpls traffic-eng name
P2MP-DYN-DST-LIST
Related Commands
id
d
estination-list-identifier
Specifies the number of a destination list. Valid range of numbers is
1–65535.
name
d
estination-list-name
Specifies the name of a destination list.
Release Modification
12.2(33)SRE This command was introduced.
Command Description
show mpls traffic-eng
t
unnels
Displays MPLS TE tunnels.
tunnel destination list
m
pls traffic-eng
Specifies the list of MPLS TE P2MP destinations.