Specifications

tunnel destination mesh-group
MP-846
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel destination mesh-group
To specify a mesh group that an autotemplate interface uses to signal tunnels for all mesh group
members, use the tunnel destination mesh group command in interface configuration mode. To remove
a mesh group from the template, use the no form of this command.
tunnel destination mesh-group m
esh-group-id
no tunnel destination mesh-group m
esh-group-id
Syntax Description
Command Default Mesh-groups are not advertised.
Command Modes Interface configuration (config-if)#
Command History
Usage Guidelines Use this command to associate a specific mesh group with an autotemplate. When a mesh group is
as
sociated with an autotemplate, the template interface signals tunnels for all mesh group members.
Examples The following example shows how to configure an autotemplate to signal tunnels for mesh group 10:
Router(config)# interface auto-template 1
Router(config-if)# tunnel destination mesh-group 10
Related Commands
mesh-group-id Number that identifies a specific mesh group.
Release Modification
12.0(29)S This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Command Description
mpls traffic-eng mesh-group Configures an IGP to allow MPLS TE LSRs that belong to the same
me
sh group to signal tunnels to the local router.