Specifications

tunnel mode mpls traffic-eng
MP-848
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel mode mpls traffic-eng
To set the mode of a tunnel to Multiprotocol Label Switching (MPLS) for traffic engineering, use the
tunnel mode mpls traffic-eng command in interface configuration mode. To disable this feature, use
the no form of this command.
tunnel mode mpls traffic-eng
no tunnel mode mpls traffic-eng
Syntax Description This command has no arguments or keywords.
Defaults Disabled.
Command Modes Interface configuration
Command History
Usage Guidelines This command specifies that the tunnel interface is for an MPLS traffic engineering tunnel and enables
t
he various tunnel MPLS configuration options.
Examples The following example shows how to set the mode of the tunnel to MPLS traffic engineering:
Router(config-if)# tunnel mode mpls traffic-eng
Related Commands
Release Modification
12.0(5)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.
Command Description
tunnel mpls traffic-eng affinity Configures an affinity for an MPLS traffic
eng
ineering tunnel.
tunnel mpls traffic-eng autoroute announce Instructs the IGP to use the tunnel in its enhanced
SP
F algorithm calculation (if the tunnel is up).
tunnel mpls traffic-eng bandwidth Configures the bandwidth required for an MPLS
t
raffic engineering tunnel.