Specifications

tunnel mode mpls traffic-eng point-to-multipoint
MP-850
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel mode mpls traffic-eng point-to-multipoint
To enable the configuration of a Multiprotocol Label Switching (MPLS) traffic engineering (TE)
point-to-multipoint (P2MP) tunnel, use the tunnel mode mpls traffic-eng point-to-multipoint
command in interface configuration mode. To remove the tunnel, use the no form of this command.
tunnel mode mpls traffic-eng point-to-multipoint
no tunnel mode
Syntax Description This command has no arguments or keywords.
Command Default No point-to-multipoint tunnel mode is enabled.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines Use the command to differentiate point-to-multipoint tunnels from point-to-point tunnels.
Examples The following example configures point-to-multipoint traffic engineering on tunnel interface 1:
Router# interface Tunnel1
Router(config-if)# tunnel mode mpls traffic-eng point-to-multipo
int
Router(config-if)# tunnel destination list mpls traffic-eng name
P2MP-DYN-DST-LIST
Related Commands
Release Modification
12.2(33)SRE This command was introduced.
Command Description
show mpls traffic-eng
t
unnels
Displays MPLS TE tunnels.
tunnel destination list
m
pls traffic-eng
Specifies the list of MPLS TE P2MP destinations.