Specifications

tunnel mpls traffic-eng auto-bw
MP-854
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel mpls traffic-eng auto-bw
To configure a tunnel for automatic bandwidth adjustment and to control the manner in which the
bandwidth for a tunnel is adjusted, use the tunnel mpls traffic-eng auto-bw command in interface
configuration mode. To disable automatic bandwidth adjustment for a tunnel, use the no form of this
command.
tunnel mpls traffic-eng auto-bw [co
llect-bw] [frequency seconds] [max-bw number] [min-bw
number]
no tunnel mpls traffic-eng auto-bw
Syntax Description
Command Default You cannot control the manner in which the bandwidth for a tunnel is adjusted.
Command Modes Interface configuration
Command History
collect-bw (Optional) Collects output rate information for the tunnel, but does not
ad
just the tunnel’s bandwidth.
frequency se
conds (Optional) The interval between bandwidth adjustments. The specified
interval can be from 300 to 604800 seconds. Do not specify a value lower
than the output rate sampling interval specified in the mpls traffic-eng
auto-bw command.
max-bw num
ber (Optional) Maximum automatic bandwidth, in kbps, for this tunnel. The
value is from 0 to 4294967295.
min-bw num
ber (Optional) Minimum automatic bandwidth, in kbps, for this tunnel. The
value is from 0 to 4294967295. For information about the default, see
“Usage Guidelines.”
Release Modification
12.2(4)T This command was introduced.
12.2(11)S This command was integrated into Cisco IOS Release 12.2(11)S.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.