Specifications

tunnel mpls traffic-eng bandwidth
MP-862
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel mpls traffic-eng bandwidth
To configure bandwidth required for a Multiprotocol Label Switching (MPLS) traffic engineering
tunnel, use the tunnel mpls traffic-eng bandwidth command in interface configuration mode. To
disable this bandwidth configuration, use the no form of this command.
tunnel mpls traffic-eng bandwidth [sub-
pool | class-type1] bandwidth
no tunnel mpls traffic-eng bandwidth [s
ub-pool | class-type1] bandwidth
Syntax Description
Defaults Default bandwidth is 0.
Default is a global pool tunnel.
Command Modes Interface configuration
Command History
Usage Guidelines Enter the bandwidth for either a global pool (BC0) or sub-pool (BC1) tunnel, not both in the same
sta
tement. To specify both pools, you need to use this command twice, once with the sub-pool or
class-type1 keyword to specify the narrower tunnel, and once without those keywords to specify the
larger tunnel.
sub-pool (Optional) Indicates a subpool tunnel.
class-type1 (Optional) IETF-Standard syntax to indicate a sub-pool tunnel.
bandwidth The bandwidth, in kilobits per second, set aside for the MPLS traffic
eng
ineering tunnel. Range is from 1 to 4294967295.
Release Modification
12.0(5)S This command was introduced.
12.0(11)ST The sub-
pool keyword was added.
12.2(8)T This command was integrated into Cisco IOS Release 12.2(8)T.
12.2(14)S This command was integrated into Cisco IOS Release 12.2(14)S.
12.2(28)SB This command was implemented on the Cisco 10000 (PRE-2) router.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRB The cl
ass-type1 keyword was added and the global keyword was eliminated.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
i
n a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.