Specifications

tunnel mpls traffic-eng exp-bundle member
MP-868
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
tunnel mpls traffic-eng exp-bundle member
To identify which tunnel is a member (bundled tunnel) of a master tunnel, use the tunnel mpls
traffic-eng exp-bundle member command in interface configuration mode. To remove the specified
tunnel from being a member of the master tunnel, use the no form of this command.
tunnel mpls traffic-eng exp-bundle member t
unnel-number
no tunnel mpls traffic-eng exp-bundle member t
unnel-number
Syntax Description
Command Default The master tunnel has no member tunnels.
Command Modes Interface configuration
Command History
Usage Guidelines Enter the t
unnel mpls traffic-eng exp-bundle member command for each tunnel that you want to be a
member of the master tunnel. You should enter this command at least once.
Examples The following example specifies that Tunnel1 is a member of the master tunnel:
interface Tunnel200
ip unnumbered Loopback0
ip ospf cost 1
mpls ip
tunnel destination 10.10.10.10
tunnel mode mpls traffic-eng
tunnel mpls traffic-eng exp-bundle master
tunnel mpls traffic-eng exp-bundle member Tunnel1
Related Commands
tunnel-number The tunnel that belongs to a master tunnel.
Release Modification
12.2(33)SRA This command was introduced.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.
12.4(20)T This command was integrated into Cisco IOS Release 12.4(20)T.
Command Description
tunnel mpls traffic-eng exp Specifies the EXP bits that will be forwarded
o
ver a member tunnel that is part of the CBTS
bundle.
tunnel mpls traffic-eng exp-bundle master Configures a master tunnel.