Specifications

xconnect
MP-896
Cisco IOS Multiprotocol Label Switching Command Reference
January 2010
xconnect
To bind an attachment circuit to a pseudowire, and to configure an Any Transport over MPLS (AToM)
static pseudowire, use the xconnect command in one of the supported configuration modes. To restore
the default values, use the no form of this command.
xconnect pe
er-ip-address vc-id {encapsulation {l2tpv3 [manual] | mpls [manual]} | pw-class
pw-class-name }[pw-class pw-class-name] [sequencing {transmit | receive | both}]
no xconnect
Cisco uBR10012 Router and Cisco uBR7200 Series Universal Broadband Routers
xconnect peer-ip-address vc-id encapsulation mpls [pw-type]
no xconnect pe
er-ip-address vc-id encapsulation mpls [pw-type]
Syntax Description
Command Default The attachment circuit is not bound to the pseudowire.
peer-ip-address IP address of the remote provider edge (PE) peer. The remote router ID can
be
any IP address, as long as it is reachable.
vc-id The 32-bit identifier of the virtual circuit (VC) between the PE routers.
encapsulation {l2
tpv3
[manual] | mpls
[manual]}
Specifies the tunneling method to encapsulate the data in the pseudowire:
• l2tpv3—Specifies Layer 2 Tunneling Protocol, version 3 (L2TPv3) as
the tunneling method.
• mpls—Specifies Multiprotocol Label Switching (MPLS) as the
tunneling method.
• manual—Specifies that no signaling is to be used in the attachment
circuit. This keyword places the router in xconnect configuration mode
for manual configuration of the attachment circuit. Use this keyword to
manually configure an AToM or L2TPv3 static pseudowire.
pw-class
p
w-class-name
(Optional) Specifies the pseudowire class for advanced configuration.
sequencing (Optional) Sets the sequencing method to be used for packets received or
s
ent. This keyword is not supported with the AToM Static Pseudowire
Provisioning feature.
transmit Sequences data packets received from the attachment circuit.
receive Sequences data packets sent into the attachment circuit.
both Sequences data packets that are both sent and received from the attachment
circuit.
pw-type (Optional) Pseudowire type. You can specify one of the following types:
• 4—Specifies Ethernet VLAN.
• 5—Specifies Ethernet port.