User's Manual

ALPHA 9500 Interim OPERATING MANUAL

www.alpharadioproducts.com

4 Unpacking & Preparation

4.1 Unpacking

Remove the strap securing the two boxes to the pallet. Inspect both boxes for physical damage.

Save all packing material and pallet for possible future use. Contact 303-473-9232 if shipping

damage is found. Carefully unpack the ampliﬁer and transformer.

Carefully remove the ampliﬁer and place it on a workbench or table where you can install the

power transformer.

4.2 Installing the Power Transformer

It is recommended that the power transformer be installed when the amp is at or near the place

it is to be used. The chassis of the 9500 is designed for the mechanical loads it experiences when

the ampliﬁer is on a ﬂat surface with the tilt-bail up or down. If the ampliﬁer is tilted too far, such

that the transformer is cantilevered or “hanging out” to any degree, the chassis of the ampliﬁer

can distort. This may affect a number of things, from the alignment of screw holes on the top

cover to the band-switch alignment and tension. If the ampliﬁer is moved, even if only from one

site to another locally, remove the transformer to avoid the possibility of damage.

CAUTION:

Do not operate ampliﬁer without the cover in place and all cover screws

installed. Do not operate the ampliﬁer without a good RF ground connection

on the rear panel ground terminal.