Programming instructions

USER Operation of the
FS1000 Audio only intercom stations
General Operation
After a visitor has rung the bell at the entrance, the monitor will turn on automatically. You
can push the ON/OFF button and talk with the visitor. You are also able to activate the
door opener. Pushing the ON/OFF button will end the communication and the monitor will
turn off automatically. You can switch on the monitor at any time by pressing the ON/OFF
button. To switch off the monitor hold the ON/OFF button for approx. 3 seconds.
Manually switching Multiple Cameras ( if equipped)
Turn on the monitor by pressing the ON/OFF button. Pushing this button again will cycle
through all available cameras on the system.
Changing the Ring sound of your inside station
You can select one of eight different ring sounds for each indoor station by the following
method:
1. Keep the LIGHT button depressed and push the FUNCTION button. This will
play the first ringtone (make sure the station hasn’t been called shortly before,
otherwise press the ON/OFF button twice to stop communication).
2. To hear the next ringtone, continue keeping the LIGHT button depressed and
push the FUNCTION button again. The last ringtone heard will be stored
automatically.
3. The ringtone sent by the optional door bell button (connected at E & T) cannot be
changed.
4. In systems with more than one entrance there is a differentiation between the ringtone
automatically.
Adjusting the Volume of the Ringtone
1. Keep the Function button depressed and volume will decrease slowly to mute
and then increase to full volume.
2. Release the button at the desired volume level. (make sure the station hasn’t
been called shortly before, otherwise press the ON/OFF button twice to stop
communication).
Replacing an Indoor Station
The new station must be programmed into the system (See programming Instructions).