Specifications

19
We reserve the right to modify technical specifications without prior notice.
83053100bUK © Alpha-InnoTec GmbH
Transport to installation location, .
Obtain overview of the interior of the unit.
DANGER!
The electric switch cabinet inside the unit
must be closed with the cabinet’s cover!
1 3-way switching valve for
heating circuit/hot water
2 Bleeder
3 Pump ball valves
4 Circulating pump for heating
circuit/hot water
5 Hot-water tank
6 Reset knob of electric
heating element
7 Overow valve
8 Electric heating element
9 Rinsing ball valve
10 Electrical switch cabinet
11 Sensor for hot water tank
12 Hot water tank service hole
(under foam cover)
13 Hot water tank emptying
valve (under foam cover)
NOTICE.
The control element of the heat and heat pump
regulator can be a connection with a computer
or network using an network cable designed for
such pruposes, thus allowing the heating and
heat pump regulator to be controlled remotely.
If such a connection is desired, install a screened
network cable (category 6, with RJ-45 plug)
through the unit when installing the connections
and run it through the front facade of the unit,
parallel to the already-present heating and heat
pump regulator control cable.
NOTICE.
Electric heating element is connected for 6 kW
at factory. It can be connected for 2 or 4 kW on
the contactor.
For further information, see the adhesive label
on the electric heating element.
1 Adhesive label on electric
heating element
After completion of all electrical installation work,
close the switch cabinet inside the unit…
Close the front panel of the unit if no further instal-
lation work inside the unit is to be performed im-
mediately.
Rinsing and lling the unit
DANGER!
Danger of fatal injury due to electric cur-
rent!
The electric switch cabinet inside the unit
must be closed with the cabinet’s cover!
Proceed as follows:
Open unit if this has not already been done…