Specifications

Page 15Installation Instructions: Roadrunner 030 and 040 AM-2000M Upgrade
8.4AM-986 Configuration
The AM-986 board, which attaches to the AM-145 CPU board, only has one jumper.
The jumper is factory installed at location JP1 and should not be removed. Also, you
must install the bracket (DWF-20538-00) used to secure the AM-986 to the AM-145
board as indicated in the illustration.
P1
P2
ALPHA
MICROSYSTEMS
AM-986
JP1
X-BUS CONNECTORS
PIN-1
TERMPOWER DISCONNECT
JUMPER (DO NOT REMOVE)
MAC952
This bracket (DWF-20538-00) is
used to tie the AM-986 to the AM-145
CPU board. The bracket is installed
on the bottom side of the board and is
held in place with a screw inserted
through the component side of the board.
Install a 2-56 screw at this location.
AM-986 Board
PDI-00172-40, Rev. A05