Specifications

Page 17Installation Instructions: Roadrunner 030 and 040 AM-2000M Upgrade
However, AM-145 boards manufactured prior to July of 1990 may not include the
nylon standoff, in which case a 1/2" 4-40 nylon standoff and two 4-40 nylon
screws are included in the installation kit. To install the standoff:
a.Remove the phillips-head screws holding the AM-145 board to the chassis.
b.Remove the hex-screws holding the I/O connectors to the rear panel.
c.Remove the hex-nut holding the video link connector to the rear panel.
d.Lift the AM-145 board up high enough to allow you to slip a 4-40 nylon
screw into position through the hole on the solder side of the board.
e.Install the nylon standoff on the component side of the board.
f.Reinstall the AM-145 board back into its proper mounting position.
There are some AM-145 boards where the hole designed for the nylon standoff
has been plated over. If you have one of these AM-145 boards, you will not be
able to install the nylon standoff. However, this is not a problem because the small
metal bracket that connects the AM-986 to the AM-145 board is sufficient for
holding the assembly in place.
PDI-00172-40, Rev. A05