Specifications

Page 24 Installation Instructions: Roadrunner 030 & 040 AM-1000 / AM-1200 Upgrade
5.The previous figure shows the new mounting bracket (DWF-20741-00). Install
your new drive on the bracket as shown in the illustration. Make sure the 50-pin
connector on the drive is oriented as shown.
6.To install the Roadrunner board, attach one 2" long standoff to the mounting holes
located at each corner of the Roadrunner board. The standoffs and nuts attaching
the Roadrunner board to the mounting bracket are shown below; the screws that
attach the Roadrunner board to the standoffs are standard 6-32 phillips head
screws. Make sure you install the nylon washer at the location indicated in the
following figure. After all the standoffs are attached to the board, mount the
Roadrunner board on the bracket as shown. Make sure the SIMM connector on
the Roadrunner board is located at the same end of the bracket as the 50-pin
SCSI connector on the drive.
SIMM CONNECTOR
MAC932
6-32
PHILLIPS-HEAD
SCREW
2" STANDOFF
#6-32 NUT
#6 NYLON
WASHER
Mounting the Roadrunner Board
7.The completed bracket, drive, and Roadrunner board assembly can now be
placed in the chassis. The assembly must be positioned with the 50-pin connector
on the drive and the SIMM connector on the Roadrunner board pointing toward
the computer’s rear panel.
PDI-00172-10, Rev. A03