Specifications

Page C-5Roadrunner Software Configuration
For example:
:T
JOBS 1
JOBALC JOB1
;
TRMDEF TERM1,AM1000=0:19200,AM62A,100,100,100,EDITOR=15
VER
SCZDSP SCZRR.SYS
;
DEVTBL DSK1,DSK2
Once the dispatcher has been defined in your AMOSL.INI file, you must code the
SCSI dispatcher to allow it to run on your specific system.
Once you enter the product installation code (PIC), the product overlay file is
forever modified and will not accept a new PIC. This can be a problem if you
happen to enter an incorrect PIC. As a safeguard, make a copy of the dispatcher
overlay file before you do the SSD encodement. Type:
COPY SCZDSP.SAV=SCZDSP.OVR
RETURN
By saving an unmodified version of the overlay file, you will be able re-enter the
PIC if necessary.
To perform the SSD encodement, enter the following commands:
LOG SYS:
RETURN
SCZPIC
RETURN
You will be prompted for a Product Installation Code (PIC).
This PIC is a unique identifier for your system that must be purchased and
obtained from Alpha Micro. Enter the PIC, carefully verifying you have entered it
correctly and press
RETURN
.
After a brief pause, you will be returned to AMOS command level and you can
proceed with the remainder of the installation. If you see the error message
?Improper SSD after you have rebooted the computer, it probably means you
have entered the PIC incorrectly.
As mentioned above, you cannot SSD encode the same overlay twice; to
re-encode the dispatcher software, do this command first:
COPY SCZDSP.OVR=SCZDSP.SAV
RETURN
PDI-00172-10, Rev. A03