Installation guide
Page 13Installation Instructions: AM-3501 Expansion Subsystem
TRMDEF statements in your boot initialization file to reflect the expansion
interface driver for the serial ports on the moved I/O board, and the new
board address (if changed).
3.If the designated rear panel slot has a filler plate installed, you must first
remove it by removing the three external phillips-head screws that hold it in
place.
4.On the inside of the rear panel, align the cable assembly mounting plate in
the vacated panel slot and attach it to the rear panel using the same three
phillips-head mounting screws. Be sure the connector cutout "key" is
positioned toward the top (or right side) of the system chassis.
5.Once the cable assembly is secured to the host rear panel, simply plug the
end of the 60-pin flat cable into the B-channel expansion connector on the
main CPU board (refer to your computer Owner’s Manual for proper
connector designation). Ensure that the colored stripe on the cable aligns
with pin-1 on the CPU connector!
6.Reinstall the chassis top cover.
9.0ADDITIONAL DOCUMENTATION
For more information on serial I/O boards and adding new jobs to your system
initialization command file, see the following documents:
AM-355 Serial I/O Board Installation Guide
AM-358 Serial I/O Board Installation Guide
Am-359 Serial I/O Board Installation Guide
System Operator’s Guide to the System Initialization Command File
PDI-03501-00, Rev. A00