Specifications

Page E-2 AM-436-15 (-23) 324MB SCSI Drive
For AM-1400LC and AM-1600M installations, the product kit (PDB-00436-23) includes
special drive mounting brackets that must be used in order to mount this drive. These
brackets (DWF-20533-00) are drilled to match the mounting holes on the Maxtor drive.
The brackets are held in place with two phillips head screws inserted through the
chassis bottom.
You will also need to remove the plastic panel located on the front of the drive. The
panel pops off the front of the drive and there is small connector (attached to the drive
access L.E.D.) that must be un-plugged from the drive’s main electronics board. With
the front panel removed, the drive will sit correctly in its mounting position, flush on the
chassis bottom.
SCSI disk drives used in AMOS 680X0 based computers must be installed with the
drive’s signal ground isolated from the computer’s chassis ground. Before installing
your new disk drive, see Section 10 (in this document) dealing with drive isolation in
AMOS based products.
PDI-00436-20, Rev. A15