Specifications

APPENDIX I
AM-436-30(-18) 324MB SCSI Drive
50-PIN CONNECTOR
PIN #1
DC
POWER
TERMINATORS
DRIVE SELECT "0"
DRIVE SELECT "1"
DRIVE SELECT "2"
DRIVE SELECT "3"
SCSI I.D.
MODEL #
FORMATTED
CAPACITY
NUMBER
OF LOGICALS
BITMAP
SIZE
FORMAT
INTERLEAVE
ALPHA MICRO
PART NUMBER
MAC957
= JUMPER INSTALLED
MAXTOR SCSI 3-1/2" SCSI DISK DRIVE
Parity must be "enabled,"
remove the jumper at this
position.
SERIES 90 (ONLY)
SPECIAL INSTRUCTIONS
FACTORY COFIGURED,
DO NOT REMOVE THESE
TWO JUMPERS
IN = Drive supplies termination power
for the SCSI bus.
OUT = Drive does not supply termination
power for the SCSI bus.
TERMINATION POWER JUMPER
7345S 324MB 11 3778 1
PDB-00436-18 (-30)
Figure 1 — Maxtor 324MB 3-1/2" SCSI Drive
SCSI disk drives used in AMOS 680X0 based computers must be installed with the
drive’s signal ground isolated from the computer’s chassis ground. Before installing
your new disk drive, see Section 10 (in this document) dealing with drive isolation in
AMOS based products.
PDI-00436-20, Rev. A15